Assembly And Operation - Craftsman 911633 Owner's Manual

ASSEMBLY & OPERATION
NOTES SANDING HINTS
a) Slower speeds allow greater
control over the sander and For extremely small
remove material slowly.
surfaces, remove one or two
b) Higher speeds remove backing pads.
material more quickly and
produce a smoother surface.
2.
Check condition of sanding
discs often. Soft materials
3. Once sander is set at the
will clog up the disc and not
desired speed, slowly
work efficiently. Worn discs
place the sander on the
may come off the backing
workpiece to be sanded.
pad.
NOTES:
a) Keep the sander moving
3.
Clean clogged sanding
on the workpiece. Do not
discs with an old eraser.
let the sander remain in
Replace
worn discs for
one location or you will faster cutting action and
gouge the surface.
smoother finishes.
b) Move the sander in long
uniform strokes to produce 4. If sander jerks, try
a uniform result.
changing the sander speed
and make sure the radius
4.
When sanding is complete,
of the curved surface is
remove the sander from
greater than 4" (10cm).
the workpiece surface and
turn the switch OFF.
5.
. Hold sander firmly to
pre~ent it from jerking.
6.
Replace backing pads
when they become wom or
damaged.
15