Single Line Installation; Splitline Installation - Troy-Bilt TB70SS Operator's Manual

ForUsewithSingme
Line ONLY
ForUsewithSplitLine
TM
or Singme Line
Rg. 18
NOTE: SpHitLine
TM
can onHy be used with the unner ree[
with the shotted hones. SingHe[ine can be used on
either type of inner reeL Use Figure 18 to identify
the inner ree[ you have.
NOTE: AHways use the correct [ine [ength when installing
trimming [ine on the unit. The [ine may not reHease
properHy if the [ine is too bng.
Loop
Fig. 19
Single Line installation
Go To .Step 8 for 5pfitLine 7MInstallation
6. Take approximately 18 feet (6 m) of new trimming
line, loop it into two equal lengths, insert each end of
the line through one of the two holes in the inner reel
(Fig. 19). Pull the line through the inner reel so that
the loop is as small as possible.
7. Wind the lines in tight even layers, onto the reel
(Fig. 20). Wind the line in the direction indicated on
the inner reel. Place your index finger between the
two lines to stop the lines from overlapping. Do not
overlap the ends of the line. Proceed to step 11.
Fig. 20
SpiitLine TM installation
8. Take approximately 9 feet (3 m) of new trimming line.
Insert one end of the line through one of the two
holes in the inner reel (Fig. 21). Pull the line through
the inner reel until only about 4 inches is left out.
9. Insert the end of the line into the open hole in the
inner reel and pull the line tight to make the loop as
small as possible (Fig. 21).
10. Before winding, split the line back about 6 inches.
11. Wind the line in tight even layers in the direction
indicated on the inner reel.
NOTE: Faihre to wind the he in the direction indicated wi[[
cause the cutting attachment to operate incorrectly.
Loop
12.
13.
Fig. 21
Insert the ends of the line into the two holding slots
(Fig. 22).
Insert the ends of the line through the eyelets in the
outer spool and place inner reel with spring inside the
outer spool (Fig. 23). Push the inner reel and outer
spool together. While holding the inner reel and outer
spool, grasp the ends and pull firmly to release the
line from the holding slots in the reel.
Holding SJots
Fig. 22
NOTE: The spring must be assemMed on the inner reel
before reassembling the cutting attachment.
14. Hold the inner reel in phce and install the bump knob
by turning clockwise. Tighten securely.
dl
Spring
Fig. 23
13