Sanyo CLT1554 Owner's Manual page 6

Getting Started
Quick Tips
m The TV will automati-
cally select the correct
Antenna mode for the
type of RF signal you
connect.
m TV will switch off
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception--When
the Video mode is
selected, the TV will
not automatically
switch off when signal
reception has stopped
for 15 minutes.
m Ifyou move the TVto
a new location, press
the RESET key twice
after connecting the
signal and turning on
the T_/
Needhelp?
VisiiourWebsiteat
www.sanyocfv.€om
orCall1-800-877-5032
Installing Batteries in the Remote Control
Use 2 "AAA" batteries (,'_)_t supplied).
Be sure batteries are installed correctly.
Note: Do not mix o/d batteries with new ones
or mix different types of batteries togethe_
Connecting Cable service, RF antenna, or Satellite Receiver to the TV
CABLE SATELLITE RECEIVER RF ANTENNA
VCR
TVBACK
TV-75 ONN
CONNECTOR
Note: If you do not have
a VCR, connect signal
directly to the TV 75 ohm
jack.
i()p_ra_Lot_al...Tipfo!:A_O Signal Connection.
If the TV is used as a monitor only, with a DVD player or some other type of external equipment, and no cable or
antenna signal is a_ ailable, the fbllowing setup is necessary:
Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press
the MENU key, enabling the TV to automatically go through the channel search process befbre you can operate the
TV. After the initial channel search is completed, you nmst press the MENU key again to complete the channel search
process, it will take a few minutes for the TV to complete searching.
After channel search is complete (2 searches), you can press the iNPUT key on the remote control to use the TV as a
monitor.
CATVFRANCHISE NOTE: Cablecompanies,like public utilities, are franchised by localgovernment authorities. To receivecableprograms,
evenwith equipmentwhich is capableof receivingcable channels,the consumer must subscribe to the cablecompany's service.
Installing Batteries / Signal Connection: Cable, Antenna, or Satellite Receiver