Connecting A Vcr; Connecting An S-Vhs Vcr - Samsung FP-T5084 Owner's Instructions Manual

Connecting a VCR
Video Connection
These instructions assume that you havealready connected your TV to an antenna or a cable TV system (according
to the instructions on pages 9~10). Skip step 1 if you have not yet connected to an antenna or a cable system.
1 Unplug the cable or antenna
from the back of the TV.
2 Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
3 Connect anAntenna Cabie
between the ANT OUT
terminal on the VCR and the
ANT 1 IN(AIR)orANT 2 IN
(CABLE) terminal on the TV.
4 Connect a Video Cable
between the VIDEO OUT
jack on the VCR and theAV
IN 1 [VIDEO] jack on the TV.
5 ConnectAudio Cables
between the AUDIO OUT
jacks on the VCR and the AV
IN 1 JR-AUDIO-L] jacks on
the TV.
_-- If you have a "mono"
(non-stereo) VCR, use a Y-
connector (not supplied) to
hook up to the right and left
audio input jacks of the TV.
If your VCR is stereo, you
must connect two cables.
TV Rear Panel
_-- Each VCR has a different back panel configuration.
_,_ When connecting a VCR, match the color of the connection terminal to the cable.
S-Video Connection
Your Samsung TV can be connected to the S-Video jack of a VCR.
(This connection delivers a better picture when compared to the regular Video connection above.)
1 To begin, foitow steps 1-3
in the previous section to
connect the antenna or cable
to your VCR and your TV.
2 Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and theAV
IN 1 IS-VIDEO] jack on the
TV.
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the AV
IN 1 JR-AUDIO-L] jacks on
the TV.
VCR Rear Panel
TV Rear Panel
_l Audio Cable (Not supplied)
An S-Video may be included with your VCR. (if not, check your local electronics store.)
_-- Each VCR has a different back panel configuration.
_,_ When connecting a VCR, match the color of the connection terminal to the cable.