Table of Contents
Advertisement
Location
of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
1. Single element:
Left rear
2. Single element:
Right rear
3. Single element:
Left front
4. Dual element:
Right front
5. Warming
center:
Center rear
o
m
©
0
0
Z
0
Hot surface indicator
,, Comes on when the unit is turned on or hot to the touch.
,, Stays on even after the unit is turned off.
HOT SURFACE
• Glows until the unit is cooled to approximately 150°F.
Cooking
areas
• The cooking areas on your range are identified by permanent circles on the glass cooking
surface. For the most efficient cooking, fit the pan size to the element size.
• Pans should
not extend more than 1/2"to 1" beyond the cooking
area.
= When a control is turned on, a glow can be seen through the glass cooking surface. The
element
will cycle on and off to maintain
the preset heat setting,
even at high settings.
= For more information on selecting proper types of cookware, refer to the section "Using the
proper cookware" on page 14.
Surface cookng 11
Advertisement
Table of Contents
Troubleshooting
