Table of Contents
Advertisement
Installation
- To avoid picture noise (interference),
leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides
of the screen may remain visible on the screen.
_
/ i_ii ¸ /
ii
i
..........
_
VCR
i
AUDIO I.PUT VIDEO _NPUT
_
'
i
i
Connect the RF antenn a out socket of the VCR to the Antenna Socket on the set:
_
Connect the antenna Cable to the RF antenna in socket Of the VCR.
6_}
Set VCR output switch to 3 or 4 and then tune Tv to the same Channel numberl
Q
Insert a vide0 taPe into the VC R and press PLAY On the VCR. (Refer to ihe VC R owner S manua I.)
32, 37, 42 inch TV Back
26 inch TV Back
_UDI0_0N0
_-VIDEO
MONITOR
_
_]
JpUT
VCR
L
AUDIO
INPUT
VIDEC
[]
=FJ
=o J::
Connect the AUDIO/VIDEO
jacks between TV and VCR. Match the jack colors IVideo = yellow. Audio Left
= white, and Audio Right = red/
Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual./
Select Video1 input source using the TV/VIDEO button on the remote control.
- f connected to IN2 _or VIDEO2L select Video2 input source.
_,f_,_
° If you have a mono VCR. connect the audio cable from the VCR to the AUDIO L/MONO jack
_L_ _
of the set.
22
Advertisement
Table of Contents
