Programming The Remote; Testing The Remote - RCA F32668YX53 User Manual

Guide plus+
Table of Contents

Advertisement

Programming
the Remote
The universal remote can be programmed
to control
most
brands of remote controllable
VCRs, receivers, etc.The remote is
already
programmed
to control
most RCA, GE and PROSCAN
"FVs,VCRs, DVD players, laserdisc
players and satellite
receivers.
Testing
the Remote
To determine
whether
the universal
remote needs to be
programmed,
turn a device ON, such as a VCR, point the remote
at theVCR, and press theVCR1
button.Then
press ON-OFF or
CH ^ (channel up) or CH v (channel down) to see if theVCR
responds to the remote commands.
If not, the remote needs to
be programmed.
Progrmmning
the Remote
Using
Al_tomatic
Code
Search
The following
instructions can be used to program
the remote
to control each of the devices connected
to yourTV.
If you want
to exit the automatic
code search without
programming
any of
your devices, press and hold CLEAR until the LED turns off.
I.
2.
Turn on the device you want to control
(VCR, SAT, etc.).
Press and hold the button you want to program
(VCR1,
VCR2, etc.).While
holding the device button, press and hold
ON-OFF until the red light on the remote turns on, then
release both buttons.
.
Press and release PLAY, then wait 5 seconds or until the LED
stops flashing.
At this point the remote is searching for the correct code to
program.
If, after 5 seconds, the device you want to control
does not turn off, press PLAY again to tell the remote to
search the next set of codes.
Continue
pressing
PLAY until the device turns off or you
have searched through
all of the codes.There
are 20 total
sets of codes. If the device does not turn off after pressing
PLAY 20 times, then the remote cannot control that
particular
device.
If the device you want to control
does turn off:
I.
Press and release REVERSE, then wait 2 seconds. Repeat
this step until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the
remote turns off.
_+
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all
models of all brands.
24

Advertisement

Table of Contents
loading

Table of Contents