ProForm C 840 User Manual page 10

15. Press a 32mm Square Inner Cap (66) into the
Right Base (34). Attach a Base Cap (47) to the
Right Base with an M4 x 16mm Screw (107) and
an M10 x 19mm Screw (118).
Attach the Right Base (34) to the Center Base
(32) with three M10 x 68mm Bolts (113), three
M10 Washers (99), and two M10 Nylon Locknuts
(97). Do not tighten the Locknuts yet.
16. Using a rubber mallet, tap the left Rack Foot (46)
into the Left Base (35). Attach the Rack Foot to
the Left Base with two M10 x 68mm Bolts (113),
four M10 Washers (99), and two M10 Nylon
Locknuts (97). Do not tighten the Locknuts yet,
Attach the other Rack Foot (not shown) to the
Right Base (not shown) in the same manner.
17. Attach the Right Spotter Hook (53) to a Safety
Spotter (52) with an M8 x 12mm Shoulder Bolt
(131) and an M8 Nylon Locknut (96). Make sure
the bolt head is on the same side as the han-
dle.
Slide the Safety Spotter (52) onto the right Guide
Bar (41) and engage the Right Spotter Hook (53)
into an adjustment hole near the bottom of the
Right Upright (133).
Assemble the Left Spotter Hook (54) and a
Safety Spotter (52) in the same manner.
Always set both Safety Spotters (52) at the
same height.
18. Identify the Left and Right Barbell Gliders (51,
123) by the position of the screw holes.
Slide each Barbell Glider (51,123) onto the
Guide Bar (41) next to the indicated Upright (36,
133). Make sure the Barbell Gliders are orient-
ed as shown.
15
47
113 66
34 1o7
16
!
17
Handle
96 53_ _//
52_131
41_ " --133
131
52_ g6
/ Adjustment Hole
18
Screw_
Hole _ _"123
414
(
J/2
133
51 -- "_Screw
Hole
41--i/_
_-36
jl/j
10