Assembly - ProForm 540 s User Manual

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wr_ and your own phillips screwdriver (_=======,P,
rubber mallet _ , and wire cutters _ .
For help identifying assembly hardware, refer to the drawings below. Note: The assembly hardware and
other small parts are packaged in separate part bags. If a part is not found in the part bags, check to see if
the part has been preattached. If a part is missing, call toll-free 1-800-999-3756.
3/4" Screw (6)-2 3/4" Tek Screw (47)-8
©
_ 1/4" Star Washer
(92)-4
1/4" x 1" Bolt
(122)-4 (71)-4
1. With the help of e second person, carefully raise the
Uprights (109) to the position shown.
Insert one of the Extension Legs (128) into the treadmill
as shown. Make sure that the Extension Leg is turned so
the Base Pad (100) is beneath it. Note: It may be helpful
to tip the Uprights (109) forward as you insert the
Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
109
128
100