Table of Contents
Advertisement
Step 1: What's in the Box?
The following
items come packed in the box:
VCR
Remote control
RF coaxial cable
Step 2: Install Batteries
in the Remote
Control
Follow these steps whenever
you need to install or change the
batteries
in your VCR's remote.
1.
Remove the cover of the battery compartment.
2.
Place the batteries into the remote's back panel. Match the
positive
(+) and negative (-) ands of each battery to the
diagram inside the battery compartment.
3,
Replace the cover,
S
J
Step 3: Connect
Your VCR
If you connect
your VCR to your home antenna or cable system
and then to your TV, use the VCR's IN (FROM ANT.) and OUT (TO
TV) jacks for a good signal as shown to the right.
If you have a TV with AUDIO/VIDEO
jacks, use the jacks for a
better connection.
Refer to the section, Connections,
toward
the back of the manual, for additional
connection
options.
Step 4: Plug in the VCR
Your VCR's power cord has a plastic band strung through
the
blades. Remove
plastic
band before
plugging
the cord
into the power
outlet.
To remove band, cut with a pair of
scissors and pull it free of the blades. Once the plastic is
removed, match the wide blade of the power cord to the wide
slot in the AC outlet. Be sure to insert the plug completely.
IV
CABLE, CABLE BOX, OR ANTENNA_
4
Advertisement
Table of Contents
