Table of Contents
Advertisement
Time counter
not working
or time counter
not working
in search
modes
The time counter
does not advance during
unrecorded
portions
of
tape. When an unrecorded
segment
of tape is encountered,
the
time counter will hold its count until recorded
material
is detected
again.
A minus (-) will appear in front of the time if you rewind
the tape
farther back than a counter
reading of O:OO:OO.
The time counter
disappears
during
search; this is normal.
Will not record or play
Check to make sure there is a tape in the VCR.
Try ejecting
and reinserting
the cassette.
Check to make sure the tape is not broken.
Check to make sure the VCR is not in pause mode. Press PAUSE or
PLAY to return to normal
playback.
Check the ProTect Plus
TM
feature.
Rewind does not operate
Check to make sure the tape is not already rewound.
VCR Plus+ system
or timer recording
not made or wrong program
recorded
Check to make sure the correct VCR Plus+ system code is entered.
Check to make sure the cable box or satellite
receiver was turned
on when recording
was to begin.
Check to make sure the program
was entered correctly
(wrong
channel
or times).
Power interruption.
Reset the clock.
Check to see if time and date are correct - including AM/PM.
Check to make sure the program
did not exceed the tape's length or
the tape was not rewound
beforehand.
Check to make sure the VCR was turned off at the time recording
was to start.
Check to make sure there was a tape in the VCR and the cassette's
safety tab was intact.
VCR ejects cassette when the end of the tape is reached during a
timer recording.
Check to make sure VCR Plus+ system setup was completed
correctly.
57
Advertisement
Table of Contents
