Table of Contents
Advertisement
Time
Counter
The time counter shows the actual time it takes to record a
program
or play back a segment
of a recorded tape. It helps
locate the beginning
or end of programs
you taped. The time
counter resets to 0:00:00 whenever
the tape is ejected from
the VCR.
For example,
if you record a 30-minute
program
at the
beginning
of the tape and you want to go to the end of
that program
to begin another recording,
you would:
1.
Press INFO twice
to display the time counter.
2.
Press CLEAR to reset the time counter to 0:00:00.
3.
Press FORWARD to forward
the tape until the time counter
reads 0:30:00.
4.
Press STOP, This is the approximate
end of the program.
(You may want to press PLAY to verify.) Now, you can
begin recording
at this spot.
5.
Press INFO twice to remove the time counter from the
screen and return to the normal
display mode.
On-Screen
Displays
The INFO button shows the status of the VCR (STOP, PLAY,
RECORD, etc.), channel
number, time counter, date, time, and
tape speed on the TV screen. The date and time must be set
before they can be displayed.
1.
Press INFO to see the on-screen displays.
2.
Press INFO again to have only the time counter remain
on the screen.
3.
Press INFO again to have no displays
appear on the
TV screen. This is useful for dubbing
tapes.
Turning off the VCR also resets the displays.
0:30:00
1
HOURS
MINUTES
Stop
Ch
05
_0:30:00
1
SECONDS
11/18199
Thu
01:30PM
SLP
On-Screen Display (-times Out)
2
0:30:00
Time Counter Only (Does Not _rne Out)
3
i
No Displays
Will Appear
(Useful
for Dubbing)
43
Advertisement
Table of Contents
