ASSEMBLY
HOW TO SET UP YOUR TRACTOR
SEAT PAN
INSTALL
SEAT
(See Fig. 2)
Adjust seat before tightening adjustment bolt.
•
Remove adjustment bolt, lock washer and flat washer
securing seat to cardboard packing and set aside for
assembly of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder
bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble
adjust-
ment bolt, Iockwasher and flat washer loosely. Do not
tighten
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable
position
is reached
which allows you to press clutch/brake
pedal all the
way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely.
SHOULDER
BOLT
FLATWASHER
LOCKWASHER_
il
ADJUSTMENT
BOLT
FIG. 2
CHECK
BATTERY
(See Fig. 3)
•
Lift seat pan to raised position.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BA'I-I'ERY" in MAINTENANCE
section of this
manual for charging instructions).
LABEL
7
FIG. 3
NOTE: You may now roll or drive your tractor off the sk d
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLLTRACTOR
OFF
SKID
(See Op-
eration
section
for location
and function
of
controls)
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Release parking
brake by depressing
clutch/brake
pedal.
Place freewheel control in "transmission disengaged
position" (See =TO TRANSPORT"
in the Operation
section of this manual).
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
TO DRIVE
TRACTOR
OFF
SKID
(See
Op-
eration
section
for location
and function
of
controls)
_Jl,WARNING: Before starting, read, understandand follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Place freewheel control in "transmission engaged"
position (see "TO TRANSPORT" in Operation section
of this manual).
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place motion control lever in neutral (N) position.
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Start the engine. After engine has started, movethrottle
control to idle position.
•
Release parking brake.
•
Slowly move the motion control leverforward and slowly
drive tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.