Advertisement
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS
INJURY, BEFORE
PERFORMING
ANY SERVICE
OR ADJUST-
MENTS:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place motion control lever in neutral (N) position.
•
Place attachment clutch in "DISENGAGED"
position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER (See Fig. 17)
Mower will be easier to remove from the right side of trac-
tor.
Place attachment clutch in "DISENGAGED"
position.
Move attachment lift lever forward to lower mower to
its lowest position.
•
Roll belt off engine pulley.
•
Remove small retainer spring, and remove clutch spring
off pulley bolt.
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
•
Disconnect anti-swaybar from chassis bracket by re-
moving retainer spdng.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:IF ANATTACHMENTOTHERTHAN THE MOWER
DECK ISTO BE MOUNTEDON THE TRACTOR, REMOVETHE
FRONTLINKSANDHOOKTHECLUTCHSPRINGINTOSQUARE
HOLE IN FRAME.
SMALL
RETAINER
SPRING
SMALL RETAINER
SPRING
TO INSTALL
MOWER (See Fig. 17)
Raise attachment lift lever to its highest position.
Slide mower under tractor with deflector shield to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs..
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-swaybar to chassis bracket and secure
with retainer spring.
•
Push clutch cable housing guide into bracket, slide col-
lar onto guide and secure with large retainer spring.
•
Place fiat washer and clutch spring on idler pulley bolt
and secure with small retainer spring.
•
Install belt onto engine pulley.
TO LEVEL MOWER
HOUSING
Adjust the mower while tractor is parked on level ground
or driveway. Make sure tires are properly inflated (See
=PRODUCT SPECIFICATIONS" section of this manual). If
tires are over or underinflated, you will not properly adjust
your mower.
CLUTCH SPRING
RETAINER
SPRING,
FRONT LINK
ANTI-SWA
COLLAR
RETAINER
SPRINGS
(BOTH SLOES)
HOUSING
GUIDE
LARGE RETAINER
SPRING
DEFLECTOR
SHIELD
FIG. 17
19
Advertisement
Troubleshooting
