Advertisement
SERVICE AND ADJUSTMENTS
MOTION CONTROL
, NEUTRAL
LEVER
LOCK GATE
ADJUSTMENT
BOLT
FIG. 25
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission require removal for service or
replacement, it should be purged after reinstallation and
before operat!ngthe tractor. See"PURGETRANSMISSION"
in the Operation section of this manual.
TO
ADJUST
STEERING
WHEEL
ALIGN-
MENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel too-in and camber are not adjustable on
yourtractor. If damage has occurred to affect the front wheel
toe-in or camber, contact your nearest authorized service
center/department.
TO REMOVE
WHEEL
FOR
REPAIRS
(See Fig. 26)
•
Block up axle securely.
•
Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose).
•
Repair tire and reassemble.
•
On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.
Replace washers and snap retaining ring securely in
axle groove.
•
Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due
to slow leaks, tire sealant may be purchased from your
local parts dealer. Tire sealant also prevents tire dry rot
and corrosion.
WASHERS
RETAINING
SQUARE KEY (REAR_
I
WHEEL ONLY)
FIG, 26
TO START ENGINE
WITH A WEAK BA'n'ERY
(See Fig. 27)
WARNING:
Lead-acid batteries
gen-
erate explosive gases.
Keep sparks,
flame and smoking materials away from
, batteries.
Always wear eye protection
when around batteries.
If your battery is too weak to start the engine, it should be
recharged. (See "BATTERY" in the MAINTENANCE
sec-
tion of this manual).
If "jumper cables" are used for emergency starting, follow
this procedure:
IMPORTANT:YOUR TRACTOR IS EQUIPPEDWITH A 12 VOLT
SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT
SYSTEM, DO NOT USEYOUR TRACTOR BATI-ERYTO START
OTHER VEHICLES.
TO ATFACH JUMPER CABLES -
Connect one end of the RED cable to the POSITIVE
(+) terminal of each battery(A-B), taking care not to
short against tractor chassis.
•
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal (C) of fully charged battery.
•
Connect the other end of the BLACK cable (D) to good
chassis ground,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from chassis and then from the fully°
charged battery.
•
RED cable last from both batteries.
WEAK OR DEAD
FULLY CHARGED
BATTERY
BATTERY
FIG. 27
REPLACING
BA'n'ERY
(See Figs. 28 and 29)
22
dental grounding.
Advertisement
Troubleshooting
