Quick Installation - Audiovox FPE1909DVI Owner's Manual

When you turn on your television set for the first
time, be sure to place it on a solid stable surface.
To avoid danger, do not expose the TV to water,
or a heat source (e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid at the rear
and be sure to leave sufficient gaps around the
unit as shown.
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
Make sure the RF aerial has
been connected properly to the
TV ANTENNA input jack on the rear
of the system.
1. Press the / button to select Yes. Press the
ENTER•OK button to proceed with the initial
setup.
3. Use the / button to select Auto Scan, then press the button to enter auto scan menu. Use the /
button to select Start to Scan, press the button to begin scanning. (If you selected CATV on Step 2,
you need to select Cable System before Start to Scan). The system will automatically start to scan and
preset all available TV channels.
4. After scanning has finished the system will return to the first TV channel scanned.

QUICK INSTALLATION

2 3/8"
2. Use the / button to select Antenna, then
E - 5
2 3/8"
press the / button to select Air or CATV.
7 7/8"