Installation - Porter-Cable CPL6025 Instruction Manual

INSTALLATION
Items Needed for Assembly
a 9/16" socket or open-end wrench for attaching the wheels
Installing Wheels and Rubber Foot Strip
I_ It may be necessary to brace or support one end of the
unit when attaching the wheels because the air compressor will have
a tendency to tip.
1. Attach rubber feet with the screws, washers and nuts provided. Tighten securely.
2. Place shoulder bolt through wheel and position it into the top hole of the
mounting bracket (protruding hub to the inside)• Thread nut onto shoulder bolt
and tighten firmly with a 9/16" wrench. Repeat to install second wheel.
Installing Handle
THE WHEELS AND HANDLE DO NOT PROVIDE
ADEQUATE CLEARANCE, STABILITY OR SUPPORT FOR PULLING
THE UNIT UP AND DOWN STAIRS OR STEPS. THE UNIT MUST BE
LIFTED OR PUSHED UP A RAMP. DO NOT LIFT THE UNIT BY THE
MANIFOLD ASSEMBLY. THE UNIT CAN BE DAMAGED.
1. Submerge handle grip into warm soapy water to make installationeasier.
Remove handle grip from soapy water and slide onto handle.
2. Insert the open end of the handle under the saddle (Fig. 3). Before attaching
handle, you may have to pull the open ends of the handle apart so they fit
tightly against the side of the saddle. Looking in from the open end of the
saddle, position the handle toward the two bent tabs, on the inside walls of the
saddle. Slowly push the open ends of the handle onto both tabs at the same
time (Fig. 4). Continue pushing the handle into the saddle until the holes on the
side of the saddle and handle are in line.
3. Guide the straight end of each retaining clip through the saddle hole and both
handle holes (Fig. 5).
B_NT TAIB _1_
Fig. 3 Fig. 4
E_4938 8 ENG