RCA PTK195 User Manual page 9

Sample Connections
The following are sample connection scenarios which you may encounter
when connecting components to your TM
Cables
You will use the following cable to make your connection:
Coaxial Cables: Carries the signal from the
antenna or cable directly to the television or
through a cable box, as needed by your cable
system.
Audio/Video Cables: Carries sound and video
from the component to the TV.
S-Video Cable: Carries video from an S-Video
capable component which provides best
picture quality.
TV and Stereo VCR
CABLE, CABLE BOX, OR ANTENNA
Cautions:
Position cables to AvoidAudio Hum
orlnterference
• Insert all cables firmly into jacks.
• Place the audio/video cables to the
sides of the TV's back panel instead of
straight down the middle.
• Try not to coil any twin-lead cables and
keep them away from the audio/video
cables.
Protect your components from
Overheating
• Do not block ventilation holes in any of
the components. Arrange the
components so that air can circulate
freely.
• Do not stack components,
• Allow adequate ventilation when
placing your components in a stand,
• Place an amplifier on the top shelf of
the stand so heated air rising from it
will not flow around other
components,
VCR
iN FROM ANTcH 3
,.eee e c.4
M_DEO R AUDIO L
OUT TO TV
o0T e e e
I
TV
+mare +L_T-
PUT 2
INP
'-I ¥
Once you have completed this connection go to "Step 3:
Connect the G-LINK Cable" on page 9.
How to View Your VCR
To watch the VCR in this connection, press TV to put the
remote control into TV mode, then press WHO•INPUT to
scroll through the video input channels until you tune to
VlD1 input.
In the Interactive Setup section you can program the TV to
automatically tune to the VlD1 input channel when you
press VCR1 on the remote.
Most Audio/Video cables are combined
into one cable with three heads on
each end.
We show individual cables
in these sample
connections. Either
may be used, but _/
you must be sure to
connect Video to
_eft Aut£o
(white)
Video, Right to Right
and Left to Left,