Table of Contents
Advertisement
5.
Release button,
and then press ONoOFF to see if the component
responds to the remote commands.
If it doesn't, try pressing the
component
button
and then ONoOFF again.
6.
If you get no response, repeat these steps using the next code listed for
your brand, until the component
responds to the remote commands.
USING
THE
REMOTE
TO CONTROLA
DEVICE
Once the remote has been programmed
successfully, you are ready to use it
to control your devices.
To operate the device:
1.
Press the device button
(TV, VCR1, VCR2, AUX, or SAToCABLE) to set the
remote to control the device.
2.
Press ONoOFF to turn the device ON or OFE
3.
Use the remote
buttons that apply to that device.
MODES
OF OPERATION
Because this universal remote can control several different
components
(VCR,
Cable Box, etc.) it uses operational
modes triggered
by the component
buttons.
For example if you want the remote to control the TV, you would
press the TV button
to put the remote into TV mode before you could
control the TV.
FRONT
PANEL
If you cannot locate your remote you can use the front panel of your TV to
operate
many of the TV's features.
MENU
Brings up the Main menu. When in the menu system, it selects
highlighted
items. Also returns you to the previous
menu.
CH v
Scans down through
the current
channel list. in the menu system, it
points down to items and adjusts menu controls.
CH ^
Scans up through
the channel list. in the menu system, it points up to
items and adjusts menu controls.
VOL -
Decreases the volume. When in the menu system, VOL - is used to
point left to items and adjust menu controls.
VOL + Increases the volume. When in the menu system, VOL + is used to
point right to items and adjust menu controls.
POWER Turns the TV on and off.
I The Front Panel Block feature disables all /
front panel buttons.
For more
J
information,
see "Parental Controls,"
in
the Features and Menus section,
FRONT
A/V
JACKS
Note: Available only on models F32715 and F36715.
The jacks are located on the left side of your TV. You can access the
component
you connected
by pressing the INPUT button
on your remote
until FRNT appears on the screen.
VIDEO (in)
Allows you to connect a component
such as a VCR, camcorder
or Internet
access device.
UMono
(left audio)
and R (right
audio)
Receives audio signals from
another
component
such as a VCR, camcorder
or Internet
access device.
25
Advertisement
Table of Contents
