Table of Contents
Advertisement
_[pJ
Look
at the
channel
number
to determine
whether
you're
on the digital
or analog
input.
A 'D' appears
next
to channel
numbers
on a
digital
channel,
while
an 'A' appears
next
to
channel
numbers
on the
analog
channel
Digital
and Analog
Channels
Your TV can choose both, analog and digital channels. You can switch between
the two by pressing the ANT-CABLE button on your remote control when the
remote is in TV mode.
Digital
Channel
Primary Channel
Subchannel
(if necessary)
Digital
Channels
Digital channels
can be made up of primary channels
and subchannels.
Subchannds
(sometimes
called minor channds)
are channels
associated with the
Primary channd
(sometimes
called the major channd).
A primary channd
may
have just one subchannd
or multiple subchannels.
Direct
Tuning
to a Digital
Channel
1.
Make SUlX2 t he remote is in TV mode by pressing TV on the remote control.
2.
Press ANT-CABLE until a "1)" icon appears
next to the channel number.
3.
Enter the primary channd
number. This number
appears first. Press OK or
wait a few seconds. If you don't enter a subchannel,
the TV tunes to the
lowest digital subchannd.
4.
If the primary channd
number has fewer than two digits, and you want
to enter subchannd
numbers,
press the right arrow button to enter the
subchannd.
5.
Enter the number of the subchannel.
This number
appears to the right of the
primary channd
number.
6.
Press OK to tune to the channd
or wait a few seconds and the TV tunes to
the channd.
Note:
Once you've
run the auto
channel
search,
you
can just
use the
channel
up and down
buttons
on the remote
control
to change
channels
when
the remote's
in TV mode.
Your remote's
device buttons
Autotuning
The autotuning
feature works with RCA devices to automatically
tune the TV to
the correct channel/input.
It works with devices you have connected
to your TV
(like a VCR, DVD player, etc.). When you set up autotuning
in the menu system
you don't have to remember
to change your TV to the CMP1 input, for example,
when you want to watch a DVD on your DVD player.
Why You Should
Use the Autotuning
Feature
Autotuning
lets you go dirc('tly to the input you assign to a device button. For
example, if you have a DVD player connected
to the CMP1 input, you can have
the autotuning
feature go directly to the CMP1 input when you press the DVD
button (instead of going through the inputs until you find the DVD signal).
(,'ontinz¢c,s on nc,xt pagc,...
33
Advertisement
Table of Contents
