Table of Contents
Advertisement
HOW TO REMOVE RANGE FOR CLEANING
AND SERVICING
Follow these procedures to remove appliance for cleaning or
servicing:
1. Shut-off gas supply to the appliance.
2. Disconnect electrical supply to the appliance, if equipped.
3. Disconnect gas supply tubing to the appliance.
4. Slide range forward to disengage range from the anti-tip
bracket. See the Installation Instructions for location of
the bracket.
5. Reverse
procedure
to reinstall.
If gas line has been
disconnected,
check for gas leaks after reconnection. A
qualified servicer should disconnect and reconnect the
gas supply. See the Installation Instructions for gas leak
test method.
To prevent range from accidently tipping, range must be
secured to the floor by sliding rear leveling leg into an anti-tip
bracket supplied with the range.
WARNING:
Possible risks may result from abnormal I
usage, including excessive loading of the oven door and of]
the risk of tip over, should the appliance not be reinstalled
according to the installation instructions.
HOW TO OBTAIN SERVICE
Do not attempt to service the appliance yourself unless
directed to do so in this manual, Contact the dealer who
sold you the appliance
for service or call us, Our
telephone number is found on the separate warranty
sheet.
If your appliance
should require service or replacement
parts, contact your dealer or authorized servicer. Be sure to
have the model
and serial
numbers
of the appliance
available. See the front cover of this manual for location of
these numbers. Please review the separate warranty sheet
that comes with your appliance to see if the service you are
requesting is covered by the warranty.
If you are not satisfied with the local response to your service
requirements, write to Maytag Customer Service, P.O. Box
2370, Cleveland,
TN 37320-2370.
Include your name,
address, phone number, the complete
model and serial
numbers of the appliance, the name and address of the
dealer from whom you purchased the appliance, the date of
purchase and details concerning your problem
If you do not receive satisfactory service, you may contact
the Major Appliance Consumer Action Program by letter.
Include the information listed above.
Major Appliance Consumer Action Program
20 North Wacker Drive
Chicago, IL 60606
MACAP (Major Appliance Consumer Action Program) is an
independent agency sponsored by three trade associations
as a court of appeals on consumer complaints which have
not been resolved satisfactorily within a reasonable period of
time.
CHECK THESE
POINTS
BEFORE
YOU CALL FOR SERVICE
PROBLEM
CAUSE
CORRECTION
Surface burner fails to light,
a. power supply not connected.
b. clogged burner port(s).
c. surface control not completely turned to
the LITE position or turned too quickly
from the LtTE position.
d. power failure (pilotless ignition).
e.
on sealed burner models: Burner will not
light ifthe ignitor is damaged, soiled, wet
or if the port directly below the ignitor is
blocked.
burner assembly incorrectly installed.
a. connect power, check circuit breaker or
fuse box.
b. clean ports with straight pin or small
paper clip. See page 16 for cleaning
instructions.
c. turn control to the LITE position until the
burner
ignites,
then
turn
control
to
desired flame size.
d. see page 5 to light burner during a power
failure.
e. clean and dry burner head. If broken or
damaged, call a serviceman.
f.
f. see page 12.
Burner flame is uneven,
a. clogged burner port(_,
a. clean ports with straight pin.
(Continued next page)
Advertisement
Table of Contents
