Advertisement
Select thedigital output tobeoutput
from the optical / coaxial
digital audio output connector of the unit.
1
2
Do steps I and 2 on page 51,
1V MCOE
: L_llCox
I
Display DIGITAL
AUDIO OUTPUT screen,
1) Press
to select.
2) Press
SET.
3
_IGITALAUOIO(_J'i'p¢_
Do_YDlIItIl:SltIWIm
dl
:OFF
Select the desired
item.
(_],,(E)
(1) Press &If'
I
to select.
I 2) Press SET
I
repeatedly
for output.
"LPCM
(DVD)"
selections
OFF:
Only linearPCM of 48 kHz/16 bit is output, When
playingDVDs recordedin linearPCM of 48 kHzi20 bit or
96 kHz, no digital audiois output. (Factorypreset)
PCM: When playingDVDs recordedin linear PCM of 48 kHz/
20 bit/24 bitor 96 kHz, digitalaudio convertedto 48
kHz/16 bit is output.
(Digitaloutputof PCM audio Is restdctedto 48 kHz/16
bitor belowfor copyrightprotection.)
"Dolby Digital" selections
Bltstream:
Dolby Digital (AC-3) bitstroam (2ch-5.1ch) is output,
(Factory preset)
PCM:
PCM (2oh) of 48 kHz/16 bit is output.
"dts"
selections
OFF:
No output.(Factory preset)
Bltstream:
dts bttstmam is output.
"Dynamic
Range Compression"
selections
OFF:
Normal audio range is selected, (Factory preset)
ON:
For dynamic sound even at low volume, this is useful for
late-night listening, [onlby Digital (AC-3) DVDs onlyI.
"V.S.S." selections
Vidual Surround Sound creates the effect of sound coming from
nonexistent rear speakers even when only connected to a
2-channel stereo system. (Dolby Digital (AC-3) DVDs only).
OFF:
No Virtual Surround Sound affect..(Factory preset)
VSS 1: Natural effect.
VSS 2: Emphasized effect.
4 %
52
Redispley DVD menu
to continue setup.
Press ACTION and go
to step 2 to setup
another setting.
Or, to exit, press
ACTION three times.
ACTION
SELECT
"2
SET
3
Recommendable setting
Type of amplifier
--
to be connected
LPCM
Dolby
dts
_OVD) 0 _1
No amplifieris conoected
OFF
3itstream
OFF
AV amplifier(withdi_daf
I
audio input ¢omlecfor)
PCM.1 ! PCM*=
OFF*2
withoutDofoyDigital/dts
decoder
!AV amplifierIncluding
DoibyDigitaldecoder
PCM .1 ]itstraam
OFF
_.Vamplifierincluding
,:
Dolby DipltaVdts decoder
PGM.1 3itstmam Bitstrearr
• Make seffings accordingto amplifier connected to optical/
coaxial audio output8s shown lo above tabte.
• When a dts decoder is not connected, to enjoy dis DVD,
please seksctaudio output other than (Its st the dts DVD
menu screen. Otherwise, there will be no sound from the
unit speakers,
•1 Audio output from unit is convertedto 48 kHz/16
bit in addition to audio from digital audio output,
TO enjoy high qualitysound at 48 kH_
bit/24
bit or 96 kHz, connect the amplifier or decoder
directly to the audio cx_out connectors, not tothe digital
audio output connector. (Select"OFF" at _ "LFCM{DVD)".)
,2 When connectingan amplifier (withan optical/
coaxial digital inputconnector) which does not
contain the Dothy Digital (AC-3) or dts decoder,
be sora to soisct =PCM" o€"Off",
ff'Bltstraam" Is belaCied, sta_ng DVD play may cause •
such a h_ghk)vel of noiso as to be harm_
to your ears and damage the speakers.
•3 When a dts decoder is connected, please select
•Bitstrssrn"in "dts'. If "OFF' is selected, there will be no
sound.
• The virtualsurround effect may notworkpropedyforsome
DVD software.
•Tum off othersurround effectswhen usingIbis vidual
surround effect.
• For optimumeffect,the distancebebNeefl t heunHand the
listenershoutdbe about3 or 4 tJmasthedistancebetween
the dg_ aed fort front sbeakers.
ii[,] I _ t.-I.-I
I.-I
I_ n I[_I-.,II_.I
ii I I;[ilo_-III _..'| _T!Y|I_'_41
Advertisement
