Before Using
1.
Remote Control
(EUR7627Z20)
2.
Batteries 2"AA"
3.
RGB Cable (2 m)
(LSJA0239-1 or LSJA0443)
Remote Control
Battery Installation
Requires two AA batteries (supplied).
While pressing in on the catch,
open cover in direction of arrow.
2.
Install the batteries as shown in
3.
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
Press cover in direction of
arrow until it snaps shut.
Two AA size
incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote
control.
Observe the following
precautions:
1.
Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2.
Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
3.
Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4.
Battery replacement is necessary when the remote control acts sporadically or stops operating the projection
display set.
7