Direct Measurement Mode; Preset D-0 - Nikon D7000 User Manual

5
Check the results.
If the camera was able to measure a value for white
balance, Faood will flash in the control panel for about
six seconds, while the viewfinder will show a flashing
Gd.
If lighting is too dark or too bright, the camera may be
unable to measure white balance. A flashing no ud
will appear in the control panel and viewfinder for
about six seconds. Press the shutter-release button
halfway to return to Step 4 and measure white balance
again.
Good_
/ / I \ I
I
Pr Ep,_J
Con trol panel
Viewfinder
P _ E,,EI
l
Con trol panel
_.__1//.
Viewfinder
6
Select preset d-0.
If the new value for preset white balance will be used immediately, select preset
d-0 by pressing the WBbutton and rotating the sub-command dial until d-0 is
displayed in the control panel.
[I_ Direct Measurement Mode
If no operations are performed while the displays are flashing, direct measurement mode
will end in the time selected for Custom Setting c2 (Auto meter-off delay, _ 214).
[] Preset d-O
The new value for white balance will be stored in preset d-0,
automatically replacing the previous value for this preset (no
confirmation dialog will be displayed). A thumbnail will be
displayed in the preset white balance list (_ 126).
To use the new value for white balance, select preset d-0 (if no value has been measured for
white balance before d-0 is selected, white balance will be set to a color temperature of
5,200 K, the same as Direct sunlight). The new white balance value will remain in preset d-
Ountil white balance is measured again. By copying preset d-0 to one of the other presets
before measuring a new value for white balance, up to five white balance values can be
stored (_ 126).
125