Dell Precision 490 Desktop User Manual page 145

Attachment failed to respond —
Bad command or file name — Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct path
name.
Bad error-correction code (ECC) on disk read —
Controller has failed — See Drive
Data error — See Drive Problems.
Decreasing available memory —
Diskette drive 0 seek failure — See
Diskette read failure — See Drive
Diskette subsystem reset failed —
Diskette write protected — Slide the write-protect notch to the open position.
Drive not ready — Put a floppy disk in the drive.
Gate A20 failure — See Lockups and Software
Hard-disk configuration error —
Hard-disk controller failure —
Hard-disk drive failure —
Hard-disk drive failure —
See Drive Problems.
Insert bootable media — Insert a bootable floppy disk, CD, or other bootable media.
Invalid configuration information - please run SETUP program —
computer configuration information.
Keyboard failure — See Keyboard
Memory address line failure at address, read value expecting value —
Memory allocation error —
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.
Memory data line failure at address, read value expecting value —
Memory double word logic failure at address, read value expecting value —
See Drive Problems.
See Drive Problems.
Problems.
See Lockups and Software Problems.
Drive Problems.
Problems.
Run the Dell Diagnostics. See (see
Problems.
Problems.
Dell Diagnostics).
Enter the system setup program (see
See Memory Problems.
System Setup) and correct the