Dell Optiplex 9010 All In One Owner's Manual page 47

Option
Strong Password
Password Configuration
Password Bypass
Password Change
TPM Security
TCM Security
HDD Protection Support
Computrace
Chassis Intrusion
Description
Enable strong password - This option is disabled by default.
This field controls the minimum and maximum number of characters allowed for the
admin and system passwords.
• Admin Password Min
• Admin Password Max
• System Password Min
• System Password Max
Allows you to bypass the System Password and the internal HDD password prompts
during a system restart.
• Disabled (selected by default) — Always prompt for the system and internal
HDD password when they are set.
• Reboot Bypass — Bypass the password prompts on restarts (warm boots).
NOTE: The system will always prompt for the system and internal HDD
passwords when powered on from the off state (a cold boot). Also, the system
will always prompt for passwords on any module bay HDDs that may be present.
Allows you to determine whether changes to the system and hard disk passwords are
permitted when an administrator password is set.
• Allow Non-Admin Password Changes (selected by default)
This option lets you control whether the Trusted Platform Module (TPM) in the system
is enabled and visible to the operating system.
TPM Security (selected by default)
NOTE: Activation, deactivation, and clear options are not affected if you load the
setup program's default values. Changes to this option take effect immediately.
Allows you to enable or disable TCM security.
TCM Security (selected by default)
NOTE: Activation, deactivation, and clear options are not affected if you load the
setup program's default values. Changes to this option take effect immediately.
Allows you enable or disable the hard disk drive protection card.
HDD Protection Card - Enable/Disable
This field lets you activate or disable the BIOS module interface of the optional
Computrace Service from Absolute Software.
• Deactivate (selected by default)
• Disable
• Activate
This field controls the chassis intrusion feature.
• Disable
• Enable (selected by default)
47