Mitsubishi CS-40307 Owner's Manual page 87

Changing channels while using the PIP modes
You can use the buttons on the remote control to change the
channels of both the main image and the small PIP image, as if
your TV had two tuners.
To do this:
_]} Press the VCR channel button
(VCR CH) on the remote control
to change the channe]L of the
PIP image.
O Press the CHANNEL button on
the remote control to change
the channe:L of the main image.
Important:
_Important:
_Important:
When the source of both the main image and the PIP image is the
TV, the VCR channel (VCR C,H) button will not change the chan-
nels of the main image or the PIP image.
You must have set up the '_VCR-A" layer of your remote :for this
button to work correctly. (See "Using the remote control to operate
VCRs, cable boxes and other equipmnent" in Chapter 3.)
If you use a cable box with your VCR, do not use this button unless
your VCR is able to control your cable box. Otherwise, switch the
remote to the cable layer and use the main channel .butt.ons.
Using thePicture-in-Picture (PIP) Modes 87