Using Debug Commands - Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual

Chapter 7 Troubleshooting the Installation
Command or Action
Step 5
end
or
commit
Example:
RP/0/RP0/CPU0:router(config)# end
or
RP/0/RP0/CPU0:router(config)# commit

Using debug Commands

The debug spa command is intended for use by Cisco Systems technical support personnel.
Debugging output is assigned high priority in the CPU process and, therefore, can affect system
performance. For more information about the impact on system performance when using debug
commands, refer to Using Debug Commands on Cisco IOS XR Software.
OL-17439-01
Purpose
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
Using debug Commands
7-3