Using And Replacing The Oven Lights - KitchenAid KEBS278D Use And Care Manual

Caring for Your Oven
2. Insert small end of a door removal pin
into each door hinge.
Insert small end of
3. Remove the door removal pins from
each hole.
4. Close the door.
NOTE: If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1-4.
3. Grasp under handle and gently close
door as far as it will shut. Pull door out
at bottom to remove.
lBil|l
4. Set door aside on protected surface.
To replace:
1. Fit hinge arms into slots in frame. Push in
at lower corners to insure that hinge arms
are fully engaged.
Using and replacing
the oven lights
The oven lights will come on when you open
the oven door. To turn the lights on when the
oven door is closed, press OVEN LIGHT
on the control panel. Press _ again to
turn off the lights.
NOTES:
• Make sure the oven is cool before
replacing the light bulb.
• The oven lights will not work during the
Self-Cleaning cycle.
Replacing the oven light:
1. Unplug oven or disconnect power.
2. Remove glass light cover by grasping the
front edge of cover and pulling it away
from the side wall of the oven.
2. Open the door all the way.
3. Remove the light bulb from its socket.
Replace the bulb with another halogen
bulb (12 volt, 5 watt maximum, available
at most hardware stores).
4. Replace the light cover by snapping it
back into wall.
5. Plug in oven or reconnect power.
41