Oven Lights - Operation/Replacement - KitchenAid KEBI271W Use And Care Manual

To return oven to regular use after
a self-clean cycle:
1. Slide the Oven Lock Lever all the
way to the left.
2. Turn the Selector to OFF and the
Temperature Control fully
counterclockwise.
3. Allow oven to cool sufficiently
before wiping up any residue.
Oven self-cleaning tips:
e Evening is a good time to clean the
oven, after normal oven use is
completed.
@ Small amounts of smoke escaping
from the oven vent are normal when
oven is heavily soiled. Excessive
smoke may indicate heavy spillovers
have not been wiped up.
© Do not force the Oven Lock Lever
open when the Lock Indicator Light
is on. Damage to the lock mechanism
may result.
¢ Clean the single/upper oven
regularly, before it becomes
"excessively dirty." If oven is not
Clean after one cycle, repeat the Self-
Clean cycle.
¢ After a Self-Clean cycle, any powdery
residue can be wiped away with a
damp cloth. If white spots remain in
the oven after a Self-Clean cycle,
remove them with a non-scratch
scouring pad before using the oven
again. These spots are usually salt
residues that cannot be removed
during the Self-Clean cycle.
e If the soil removal was not complete,
increase the length of the clean time
in the next cycle.
Oven Lights —
Operation/Replacement
Oven light(s) automatically come on in
the oven(s) when an oven door is
opened. The light(s) can be turned on
when the doors are closed by pushing
the Oven Light Switch on the control
panel.
Replacing a light bulb:
Electrical Shock And
Personal Injury Hazard
e Make sure oven and light
bulb are cool and power to
the oven has been turned
OFF before replacing the
light bulb. Failure to do so
could result in electrical shock
or burns.
¢ The lens must be in place
when using the oven. The
lens protects the bulb from
breaking, and from high oven
temperatures. Broken glass
could cause injury.
1. Turn the power off at the main
power supply.
2. Remove the three screws in the
lens holder with a Phillips
screwdriver. Care should be
taken to prevent the holder and
the lens from falling into the
oven Cavity.
3. Lift holder and glass lens out.
4. Remove and replace the light bulb
with a 40-watt appliance bulb.
5. Replace the lens and the holder,
and tighten the three screws.
6. Turn the power back on at the
main power supply.
23