Needle Holder; Needle, Changing - Pfaff hobbylock 4752 Instruction Manual

Changing the needle
Switch the main switch to OFF.
Move the needle(s) to the highest position.
Loosen the fastening screw of the needle
that is to be changed.
Needle system HA X 1SP (130/705 H-PS) is
required for this machine.
edge of the
needle bar
needle
stop
fasten-
pin
ing
screw
the flat
side
points
towards
the rear
22
fastening screw
for the left needle
fastening
screw for
the right
needle
edge of the
needle bar
needle
holder
Do not use bent or blunt needles.
Inserting the right needle
Insert the new needle in such a way that
the flat side points towards the rear. Push
the needle upward until it touches the stop
pin. Tighten the fastening screw of the right
needle.
Inserting the left needle
Insert the new needle into the needle hol-
der in such a way that the flat side points
towards the rear. Push the needle upward
until it touches the edge of the needle bar.
Tighten the fastening screw of the left
needle.
– If the needles are inserted correctly,
the position of the left needle should
be slightly higher than that of the right
needle.