Presser Foot Pressure; Presser Foot, Changing - Pfaff hobbylock 4752 Instruction Manual

Standard setting
Top side of
the machine
adjusting screw
presser
foot lifter
lever
Removing the presser foot
Turn the machine off.
Raise the needle(s) to the highest position.
Raise the presser foot and press the lever
at the rear of the presser foot holder. The
presser foot will be released automatically
from the holder.
2 mm
to increase
to reduce
needle
presser foot
holder

Presser foot pressure

The presser foot pressure does not need to
be adjusted for most fabrics. If you are
working with light or heavy fabrics then
you may need to adjust the pressure. In this
case set the adjusting screw as follow:
– for heavyweight fabrics increase pres-
sure by turning the adjusting screw to
the right
– for lightweight fabrics reduce pressure
by turning the adjusting screw to the left
Adjust the adjusting screw for normal
sewing work in such a way that its upper
edge protrudes 2 mm out from the top side
of the machine (see illustration).
lever
Attaching the presser foot
Place the presser foot beneath the presser
foot holder, until the pin of the foot is dir-
ectly under the presser foot holder clamp.
Lower the presser foot holder and press
lever until the foot then clicks into place. Lift
the presser foot lever to check that the press-
ser foot is properly locked into place.
clamp
pin
21