Presser Foot; Changing The Presser Foot - Pfaff creative 4874 Instruction Manual

20
F

Presser foot

The standard presser foot has two
different positions:
Position "A" - for sewing cover stitch
(progs. 1, 2, 3), double chainstitch (prog.
4), the 4-thread safety seam (prog. 19) and
the 5-thread safety seam (prog. 20).
Position "B" - for sewing programs 05 – 18.
To choose these positions, simply move the
selection lever.
For cover stitch (progs. 1, 2, 3) and double
chainstitch (prog. 4), clearview foot F from
the accessory box can also be used.
For top cover (progs. 21, 22, 23) and deco
cover (progs. 24 – 30), use clearview foot R
R
from the accessories box.

Changing the presser foot

A
Turn off the power switch
To remove: Raise the needle(s) to its/their
highest position. Lift up the presser foot
and press lever A on the back of the
presser foot holder. The presser foot is
released automatically and you can pull it
out to the left.
To insert: Place the presser foot below
the presser foot holder so that when the
presser foot lifter is lowered, the pin on
the foot is directly beneath the presser
foot holder. Lower the presser foot and if
necessary press lever A, the presser foot
will now click back into place.
Technical section, general
Note: The position of the
presser foot, "A" or "B",
appears in the LCD display (9)
(see page 3-2).
Note: The foot you need to
use will be shown in the LCD
display (9) (see page 3-2).
Check: Lift the presser foot
to confi rm that it is correctly
attached.
2-7