Setting up the telescopic thread stand
Extend the telescopic thread stand to its full height, then
turn until it clicks into place. Place the thread spools over
the cone holders on the spool pin.
If the machine is already threaded, straighten the threads
to prevent tangling.
Front cover
Open
First push the cover to the right as far as it will go and
then pull it downward toward you.
Close
1
First pull the cover upward and then slide it to the left
until it locks.
2
Note: The front cover has a safety switch and the machine will
not sew if the front cover is open.
Attaching the waste tray
Position the machine so the front is nearly aligned with
the edge of the table. Insert the U-shaped hooks of the
waste tray onto the two suction cups on the underside of
the machine. Make sure the trim falls into the bag while
sewing.
Presser foot lift
Raise the presser foot by lowering presser foot lift at the
back of the machine.
Pressing down on the presser foot lift puts the presser foot
in the extra lift position.
8
Preparations