Preparations; Connecting The Foot Control And The Power Supply; Setting Up The Spool Stand; Setting Up The Telescopic Thread Stand - Pfaff Coverlock 3.0 Owner's Manual

Connecting the foot control and the
power supply
Foot control to use with this machine:
Before plugging your machine in, make sure the voltage
is the same as indicated on the plate under the machine.
• Connect the foot control/electric power cord to the
socket on the machine.
• Plug the power cord plug into the electric outlet.
• Press the foot control to start sewing. Use the foot
control to adjust the sewing speed. The harder you
press, the faster the machine will sew.
On the right side of the foot control is a speed control
slide (A) for selecting full or half maximum speed. If
you press the foot control to the bottom, the machine
runs at the maximum speed set by the speed control
slide. To stop the machine from sewing, remove your
foot from the control.
Note: Your coverlock™

Setting up the spool stand

Insert the spool stand then push to right as illustrated.

Setting up the telescopic thread stand

Extend the telescopic thread stand to its full height, then
turn until it clicks into place. Place the thread spools over
the cone holders on the spool pin.
If the machine is already threaded, straighten the threads
to prevent tangling.
POLARIZED PLUG INFORMATION
(FOR U.S.A. & CANADA ONLY)
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock,
electrician to install the proper outlet. Do not modify
the plug in any way.
A
ATD
C
B
A

Preparations

7