Threading The Coverstitch Left Needle - Pfaff coverlock 4.0 Owner's Manual

Hide thumbs Also See for coverlock 4.0:
Table of Contents

Advertisement

Threading the coverstitch left needle

(blue, C on the needle clamp)
• Raise the presser foot to release tension discs.
• Pass the thread from back to front through the thread
guide on the thread stand (1).
• Thread the top cover thread guide by pulling the
thread towards the left until it slips under the guide.
Then pull the thread along the right side of the button
as illustrated (2).
• Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between
the tension discs and pull it down to make certain it is
properly placed between the tension discs (3).
• Continue to thread points (4-8).
• Slip the thread into the front slot on the thread guide
(5) and into the slot on the take-up lever cover (6). Then
slip the thread into the left slot on the thread guides (7)
and (8).
• Before threading the eye of the needle, make sure the
thread is in front of the thread guide located on the
bottom of the needle clamp.
• Thread the eye of the needle (9). Use the needle
threader (see page 22) to make the threading easier.
• Pull about 10 cm (4") of thread through needle eye to
hang free.
• Place the thread to the back, under the presser foot.
1
3
2
1
2
4
6
5
7
8
9
9
Threading
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents