Preparations; Connecting The Foot Control And The Power Supply; Setting Up The Spool Stand - Pfaff coverlock 4.0 Owner's Manual

Connecting the foot control and the
power supply
Among the accessories you will nd the power cord and
the foot control.
Note: Before plugging in the foot control, check to ensure that it
is type "FR5" (see underside of foot control).
1. Pull out the cord from the foot control. Connect the foot
control to the front socket on the bottom right side of
the machine (A).
2. Connect the power cord to the rear socket on the
bottom right side of the machine (B). Plug the cord into
the wall socket.
Before plugging your machine in, make sure the voltage is the
same as indicated on the plate under the machine. Speci cations
vary from country to country.
3. Press the ON/OFF switch to ON to turn on power and
light (C).
Note: When the front cover is open the safety switch is activated
and prevents the machine from sewing, even if the foot control is
pressed.
Note: To retract the foot control cord, unplug the foot control
from the machine (A). Pull the cord gently and release - the cord
will retract itself into the foot control.
POLARIZED PLUG INFORMATION
(FOR U.S.A. & CANADA ONLY)
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock,
this plug is intended to t in a polarized outlet only
way. If the plug does not t fully in the outlet, reverse
the plug. If it still does not t, contact a quali ed
electrician to install the proper outlet. Do not modify
the plug in any way.

Setting up the spool stand

Insert the spool stand then push to right as illustrated.
B
A
C

Preparations

7