Opel Corsa Owner's Manual page 213

12. Dismantle the tyre repair kit. When
removing the sealant bottle from the
holder, press the ratchet on the holder.
Screw the tyre filler tube onto the free
connector on the sealant bottle. This
prevents the sealant from escaping.
Stow the tyre repair kit in the luggage
compartment.
13. Wipe away any sealant spill with a
cloth.
14. Fold away warning triangle 3, store in
luggage compartment 3 196.
15. Apply the sticker on the sealant bottle
showing the maximum permitted speed
within the line of sight of the driver.
Sticker 3 205, Fig. 17469 T.
16. Continue driving immediately so that
the sealant is distributed evenly
inside the tyre. After approx. 10 km
(after 10 minutes at the latest), stop
and check the tyre pressure. To do this,
screw an air tube directly to the tyre
valve and compressor.
If tyre pressure is more than 1.3 bar,
adjust to the prescribed value. Repeat
the procedure until there is no more
pressure loss.
If the tyre pressure has dropped
below 1.3 bar, the vehicle must not
be used. Contact a workshop for
assistance.
17. Stow the tyre repair kit behind the cover
on the right in the side trim in the
luggage compartment. To close, lower
the cover and engage in the trim.
Self-help, vehicle care 207
Important
The driving comfort of the repaired tyre is
severely affected, therefore have this tyre
replaced.
If the compressor makes abnormal noises
or heats up greatly, switch it off for at
least 30 minutes.
The integrated safety valve opens at a
pressure of 7 bar.
Protect the compressor from moisture and
rain.
The sealant can only be stored for
approx. 4 years. After this time, the sealing
properties can no longer be guaranteed.
Heed the expiration date on the sealant
bottle.
Replace the used sealant bottle. Dispose of
the bottle as prescribed by applicable laws.
The compressor and sealant can be used
from approx. -30 C.
The adapter 3 supplied may be used to
pump up other objects, such as balls,
airbeds, dinghies.
When using the tyre repair kit, no consumer
may be connected to the front accessory
socket at the same time.
Back to overview