Opel Corsa Owner's Manual page 186

180 Driving and operation
Picture no: 18353s.tif
Place the wheel recesses such that the
bicycle is more or less horizontal. Here, the
distance between the pedals and the
tailgate should be at least 5 cm. Setting the
wheel recesses 3 178.
Both bicycle tyres must be in the wheel
recesses. In order to prevent damage,
neither the pedal bearing housing on the
bicycle nor the pedal crank must not be
touching the pedal crank recess.
Picture no: 18354s.tif
Align the bicycle in the longitudinal
direction of the vehicle:
Loosen the locking screw on the crank
bearing fixing a little 3 177, Fig. S 14629.
Place the bicycle upright using the rotary
lever on the pedal crank recess, 3 177,
Fig. S 14629 or Fig. S 14630.
If the two bicycles obstruct one another,
the relative positions of the bicycles can be
adapted by adjusting the wheel recesses
and the rotary lever on the pedal crank
recess until the bicycles no longer touch
one another. Here, make sure there is
sufficient clearance to the vehicle.
Picture no: 18455s.tif
Tighten the attachment screw for the pedal
bearing mount to its maximum point.
Secure both bicycle wheels to wheel
recesses using strap retainers.
Check the bicycle to make sure it is secure.
The settings for the wheel recesses and on
the rotary lever on the pedal crank recess
should be noted and saved for each
bicycle. Correct presetting will facilitate
refitting of the bicycle.
Back to overview