Table of Contents
Advertisement
Change the user name and password for the BOX
"Username and password" to log into the BOX are changed. Even either of them can be changed.
Step 1
Select "2.Settings" on the BOX configuration page (+
page 17).
→ The setup window will be displayed.
→
Step 2
Select "2.BOX authentication setting".
→ The change window of the BOX user name and
→
password will be displayed.
Step 3
Click the [Execute] button after entering the user
name and password.
→ The confirmation window will be displayed.
→
Re-enter the registration details. The success window
will be displayed when the registration is successful.
This unregistered window will be displayed when the
registration is unsuccessful.
Note:
• If you forget the username and password for the
BOX, the initial username and password resume
by setting the rotary switch on the rear panel to
"8" and turning the power off and then on. After
making sure that the initial username and pass-
word resume, put the rotary switch back to "0".
This operation also allows "IP address of BOX" to
be initialized.
• Change the username, "admin" and password,
"panasonic" at shipment from the viewpoint of
security.
• Use 4 to 31 one-byte alphanumeric characters for
both username and password.
20
Advertisement
Table of Contents
