External Output - Panasonic AF-FX100 Setup Instructions

External output

The table below shows the outputs of the BOX.
Output
1 Through image
2
2 OSD image*
3
3 AVMD image*
4 Panasonic alarm
protocol
5 Communication
with control
section
(Interactive)
Be aware of the following when the BOX is registered with each output destination device:
• Specify the IP address of the BOX in the same procedure to register the IP address of a camera.
• Specify the model types of the camera/encoder to which the BOX is connected. However, the setting values
of resolution and the like shall be the same as the values that have been set for the camera.
• The BOX transfers a control command sent from each output destination device to the camera/encoder as it
is. This enables the camera/encoder to be operated as if they are directly controlled. However, the BOX
shall not support all the control operations via the BOX.
*1: Be aware of the displayed contents when an encoder is connected to the BOX and the BOX is registered
with DG-ASM100 (see Appendix 2 (+ page 64)).
*2: This is an image with a detecting area frame, a detection frame, and a detection factor (text) superimposed.
*3: This image can be displayed with DG-ASM100 only when DG-NS202A is connected to the BOX.
Description
This image is for monitoring in real time. The
output of a camera is transferred as it is with
minor delay.
This image is with which a monitoring area, a
detection point, and a detection factor of
intrusion detection are dis-playable on an NTSC
monitor or the like in real time. Storing an image
on DG-ND400 allows a detection factor to be
identified only by playing back the image.
This image is for DG-ASM100. The detected
frame information is embedded in the header
area of JPEG image data. DG-ASM100 is
equipped with a function that can display the
original image with the frame information
superimposed.
This alarm is used in the PC software
(DG-ASM100) and the monitoring recorder (DG-
ND400) of Panasonic System Networks Co., Ltd.
An alarm can be sent when an event is detected.
An alarm factor of the BOX cannot be
transmitted. Record management can be
performed by using DG-ASM100 and DG-ND400.
This is a telegraphic message between the PC
software package (AF-SX100S) and BOX. This is
equipped with a function where a detection
factor is received from the BOX and information
such as detection cancellation, test alarm, and
detection inhibition is sent to the BOX.
10
Destination devices
1
DG-ASM100* , DG-ND400,
AF-SX100S
AF-HX100DA/DE,
DG-GXD400, DG-ND400
DG-ASM100
DG-ASM100 or DG-ND400
AF-SX100S