Jenn-Air JJW8527 User Manual page 9

CLEANING
{SELEoCLEAN OVEN ]
The self-clean cycle uses above normal cooking
temperatures to automatically clean the entire
oven interior. Whilethis occurs, a device in the
oven vent helps consume normal amounts of
smoke. The oven is vented through an opening
under the control panel.
NOTE: Bothovens cannotbe self<leaned at the
sametime in doublewall ovenmodels.
It is normal for flare-ups, smoking or flaming
to
occur during cleaning if the oven is heavily
soiled.
It is better to clean the oven regularly rather
than to wait until there isa heavy build-up of soil
in the oven.
During the cleaning process, the kitchen should
be well ventilated to help eliminate normal
odors associated with cleaning.
Do not usecommercial ovencleaners on the
self-deanovenfinish or around anypart of the
oven asthey will damagethe finish or parts.
BEFORE SELFoCEANING
Remove broiler pan, all pans and the oven racks
from the oven. The oven racks will discolor
and may not slide easily a_er a self-clean
cycle.
Clean oven frame, door frame (area outside
the door gasket) and around the opening in the
door gasket with a non-abrasive cleaning agent
such as Bon Ami* or detergent and water.
These areas are not exposed to cleaning tem-
peratures and should be cleaned to prevent soil
from baking on during the clean cycle.
To prevent dam= ._ ///
age, do not clean \"_.-'_-J/S/_&__
or rub the gasket . ,_ "_:;_' /
around the oven
//
door. The gasket is "_ ......... _ .....
designed to seal in
heat during the clean cycle.
Wipe up excess grease or spillovers from the
oven bottom to prevent excessive smoking,
flare-ups or flaming during the clean cycle. For
ease of cleaning, the heating element can be
lifted slightly (I to I- I/2 inches).
Wipe up sugaryspilloversand acidicspillovers
such as lemon juice, tomato sauceor mill<-
basedsauces.Porcelainenamel is acid resis-
tant, not acid proof. The porcelain finish
may discolor if acidic spills are not wiped
up prior to a self-clean cycle.
SETTING THE CONTROLS
FOR A SELFoCLEAN CYCLE
I. Close the oven door.
.
,
Pressthe Clean pad.
• The indicator words CLEAN TIME will
flashand the displaywill show" HR:
2 (Double wall oven models will also
havea "U" or "L" indicatingupper or
lower oven.)
Press Auto Set (0) pad and "3:00" hours
will appear in the display for an average
soiled oven.
• The cleaning time can be varied depend-
ing on the amount of soil. After "3:00"
appears in the display, press the num-
ber 2 pad and enter "2:00" hours of
cleaning for light soil. The number 4 pad
will enter "4:00" hours for heavy soil.
• Five seconds after entering the cleaning
time, the oven door will automatically
latch and the cooling fan will come on.
• The indicator words LOCK and ON
will come on when the door is latched.
• The indicator word ON will cycle with
the elements as the cleaning tempera-
ture is maintained.
,
When the cleaning time has been com-
pleted, the indicator words CLEAN and
ON willgo off. The indicator word LOCK
and the cooling fan will remain on until the
oven has cooled and the door has un-
locked.
AFTER SELFoCLEAN_G
About one hour after the end of the clean
cycle, the lock will disengageand the LOCK
indicator word will turn off. At _his point,
the door can be unlocked and opened.
Somesoil may leavea lightgray, powdery ash
which can be removed with a damp cloth. If
* Brand names are registered trademarks of the respective manufacturers.
8
soil remains, it indicates that the clean cycle was
not long enough. The soil will be removed
during the next clean cycle.
Ifthe oven racks were left in the oven and do
not slide smoothly after a clean cycle, wipe
racks and embossed rack supports with a small
amount of vegetable oil to restore ease of
movement.
Awhite discoloration mayappear after cleaning
if acidic or sugary foods were not wiped up
before the clean cycle. This is normal and will
NOT affect performance.
TO DELAYTHE START OFA CLEANCYCLE:
1-3. Follow previous steps I-3.
4. Press the Stop Time pad. Indicatorwords
STOP TIME will flash in the display and
CLEAN and the calculated stop time will
also appear in the display.
5. Press the appropriate number pads to enter
the stop time. A stop time can only be
accepted for later in the day.
Example: If at 9:00 you set the oven to
clean for three hours, the calculated stop
time would be "12:00". The display will
show:
12:00
CL_
STOP TINE
Ifyou want the stop time to be I:00, press
the number pads "l,0,0". Fiveseconds later
the display will briefly show the start time
and the indicator word DELAY.
I ln:nn !
DELAY L_T _--_TI_ _ CLEAN
After a brief time, the display will return to
the current time of day with the indicator
words DELAYTIMED CLEAN remainingin
the display.
_o m
:,.Og
DELAY TIMED CLEAN
When the oven begins
to
clean, the indica-
tor word ON and the cooling fan will come
on. The indicator word DELAYwill go off.