Operator Controls; Seat; Hydrostatic Ground Drive System - Exmark LAZER ZTM Operator's Manual

2.4.2 Charging Capacity: 15 amps
2.4.3 Battery Type: BCI Group U1
2.4.4 Battery Voltage: 12 Volt
2.4.5 Polarity: Negative Ground
2.4.6 Fuses: Two 20 amp blade type
2.4.7 Safety Interlock System: Operator must be in seat with Blades disengaged,
brake engaged, and motion control levers out (neutral lock) to start
engine.
Operator must be in seat when Blades are engaged, brake is disengaged,
or motion control levers are moved in or engine will stop.
Engine will stop if either the left, the right, or both levers are moved from
neutral lock position while brake is engaged.
2.4.8 Tilt Switch: (Serial Nos. 220,000 & Higher) Shuts off the engine when the unit
is tilted more than 60 from horizontal.

2.5 OPERATOR CONTROLS

2.5.1 Steering and Motion Control:
Separate levers, on each side of the console, control speed and direction of
travel of the respective drive wheels.
Steering is controlled by varying the position of the levers relative to each
other.
Moving motion control levers outward (in slots) locks the drive system in
neutral.
2.5.2 Blade Engagement Switch: Engages electric clutch (to drive belt) which
engages mower blades.
2.5.3 Parking Brake Lever: Sets brakes.
2.5.4 Deck Height Adjustment Lever: Sets cutting height to desired position.

2.6 SEAT

2.6.1 Type: Standard seat: high back, foam padded (internal spring
suspension)with arm rests.
Optional suspension seat: high back, low profile foam-in-place cushion
(dampened, adjustable spring suspension) with armrests.
2.6.2 Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other
components. Held in tilted position with prop rod. Adjustable fore and aft seat
track.
2.6.3 Armrests: Standard seat: foam padded flip-up armrests.
2.6.4 Seat Safety Switch: Incorporated into the Safety Interlock System.
Time delay seat switch eliminates rough ground cut-outs.

2.7 HYDROSTATIC GROUND DRIVE SYSTEM

2.7.1 Hydrostatic Pumps: Two Hydro Gear BDP-10L variable displacement piston
2.7.2 Wheel Motors: Two Parker/Ross with 1 1/4" tapered shafts.
2.7.3 Hydraulic Oil Type: Synthetic Mobil 1 15W-50.
2.7.4 Hydraulic Oil Capacity: 2.1 qt.(2.0 L.)
Optional suspension seat: molded adjustable flip-up armrests.
pumps.
- 9 -