Specifications; Model Number; Engine; Fuel System - Exmark Frontrunner FR25KD Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

2. SPECIFICATIONS

2.1 MODEL NUMBER:

2.2 ENGINE

2.2.1 Engine Specifications: See your Engine Owner's Manual
2.2.2 RPM: Full Speed: 3870 RPM (No Load) +50/-100 RPM

2.3 FUEL SYSTEM

2.3.1 Capacity: 8.5 gal (32 L)
2.3.2 Type of Fuel: Diesel fuel, 40 cetane or higher.
2.3.3 Fuel Filter: 2 In-line 15 Micron Kubota P/N 12581-43012, before and after the

2.4 ELECTRICAL SYSTEM

2.4.1 Charging System:
2.4.2 Charging Capacity:
2.4.3 Battery Type: BCI Group 26
2.4.4 Battery Voltage: 12 Volt
2.4.5 Polarity: Negative Ground
2.4.6 Safety Interlock System:

2.5 COOLING SYSTEM

2.5.1 Fan: Belt driven with continuous operation with engine running.
2.5.2 Coolant Liquid: 50/50 mix of DexCool© extended life antifreeze and water.
2.5.3 Coolant Capacity: 4 quarts

2.6 OPERATOR CONTROLS

2.6.1 Steering and Motion Control:
2.6.2 PTO Engagement Switch: Engages drive to PTO (mower deck).
2.6.3 Parking Brake Lever: Pull back to engage parking brake.

2.7 SEAT

2.7.1 Type: Standard seat with high back, foam padded (internal suspension).
2.7.2 Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other
FR25KD
Idle: 1400 RPM (No Load) ±50 RPM
electric fuel pump.
External Alternator
60 amps
PTO must be disengaged, brake engaged, and speed control lever in neutral
position to start engine. (It is not necessary for the operator to be in the seat to
start the engine.)
Operator must be in seat when PTO is engaged, brake is disengaged, or speed
control lever is moved out of neutral or engine will stop.
Engine will stop if the motion control levers are moved from neutral position while
brake is engaged.
Separate levers, on each side of the console, control speed and direction of travel
of the respective drive wheels.
Steering is controlled by varying the position of the levers relative to each other.
Moving motion control levers outward (in slots) locks the drive system in neutral.
NOTE: Motion control levers are adjustable to three (3) heights.
components. The seat is held in the tilted position with a linkage. Adjustable fore and
aft seat track.
www.mymowerparts.com
12