Delta RS830 Instruction Manual page 17

11. Place an arbor wrench (D)Fig. 25, between table
board (A) and motor shaft (B). Lower track arm (X)
Fig. 24, by turning elevating handle (C) counterclockwise
until motor shaft (B)Fig. 25, barely touches arbor
wrench.
Fig. 25
12. Check the height of the table board above the other
three table board adjustment screws (E) Fig. 26, by re-
positioning track arm (X), and cutting-head assembly (V)
until the highest point of the table is determined. NOTE:
MAKE CERTAIN CUTTING-HEAD CLAMP KNOB (W)
FIG. 27 AND TRACK ARM CLAMP HANDLE (Y) ARE
TIGHTENED WHEN MOTOR SHAFT IS LOCATED
ABOVE EACH OF THE ADJUSTMENT SCREWS. DO
NOT CHANGE HEIGHT OF TRACK ARM (X) FIG. 26,
UNTIL HIGHEST SCREW IS DETERMINED, AND ALL
FOUR CORNERS OF THE TABLE BOARD HAVE BEEN
ADJUSTED.
Fig. 26
13. Position the motor shaft back over the three lower
corners of the table board and adjust the table
adjustment screws (E) Fig. 26, until the arbor wrench fits
accordingly between the arbor shaft and table board in
each location.
14. Once the table board (A) Fig. 28, is properly ad-
justed, tighten three screws (G)on each side of saw
base (H). Then return track arm (X) and motor (V) to the
90 degree position as shown, and tighten bevel clamp
lever (S) and track arm clamp handle (Y) Fig. 27.
Fig. 27
Fig. 28
17