Adjusting In/Out Rip Scale - Delta RS830 Instruction Manual

5. Placea square (D)Fig.41,onthe tableandagainst
thesawblade, a s shown, a ndcheckto seeifthe blade
is square withthetable.NOTE: T hesquareshouldrest
betweentwo teeth of the saw blade.
6. If an adjustment is necessary, makecertainbevel
clamplever (C)Fig.40, is tight. Removescrew,flat
washer, andpointer(E)Fig.40. Remove t wo screws(F)
Fig.40, and bevelscaleplate(H)Fig.42, with index
knob(A).
7. Loosenfour hex headscrews(G)Fig.42. Tilt the
motor until the saw blade is flush with the square.
Tighten fourhexheadscrews(G).
8. Replacebevelscaleplate (H)Fig.42, with bevel
indexreleaseknob (A),two screws,and pointerthat
were removedin
STEP 6. NOTE: Adjust pointer to
"zero" on the bevel index scale.
Fig. 41
ADJUSTING IN/OUT RIP SCALE
1. _ DISCONNECT MACHINE FROM POWER
SOURCE..
2. Loosen yoke clamp handle (A) Fig. 43. Release yoke
index by pressing yoke indexing release lever (B) up or
down, and rotating cutting-head (C)to the in-rip
position as shown. Tighten yoke clamp lever (A).
3. Position fence (D) Fig. 43, at the rear of table as
shown.
4. Loosen cutting-head clamp knob (G) Fig. 48 and
slide cutting-head (C) Fig. 43, to rear of track arm until
saw blade (F) is flush against fence (D).
5. Tighten cutting-head clamp knob (G) Fig. 48 and
adjust pointer (H) Fig. 43, if necessary, to "zero" mark on
lower scale (J) by loosening screw (K). After adjustment
is made, tighten screw (K).
21
Fig. 42
Fig. 43