Kenmore 665.7527 Series Use & Care Manual page 20

To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
A. Removal pins
B. Hinge hanger
2. Slowly close the door until it rests against the door removal
pins.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4. Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
4=
Insert the door stop clip with its angular surface at the top of
the frame hinge slot, then push in the bottom of the clip until
its flanges are flush with the front frame.
5. Open the door completely and remove the door removal pins.
Save door removal pins for future use.
6. Close the door.
Remove racks from inside the Triple Task Oven Drawer, and allow
the unit to cool completely before attempting to remove the
drawer.
To Remove:
1. Open drawer to its full open _osition.
2. Identify the tabs on both sides of the drawer.
A B A
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface.
2. Hold oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
slots.
3. Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
4 c
A. Hinge hanger
B. Door frame hinge
C. Support pins
3=
A. Silver tabs
B. Middle "push in" tab
Release drawer one side at a time.
While pushing in to release the middle tab, lift to release the
silver tabs.
A. Silver tab
B. Middle "push in" tab
20