Table of Contents
Advertisement
GettingStarted
Oont,nued
Unpacking
After unpacking,
check to be sure that you have all the
following
items.
The number
in the parentheses
indicates
the quantity
of the
pieces supplied.
• AM (MW) loop antenna(l)
• FM antenna
(i)
• Remote
control (i)
• Batteries
(2)
If any is missing,
consult
your dealer
immediately.
Puttingthe Batteriesintothe RemoteControl
Insert the batteries--R6P(SUM-3)/AA(15F)--into
the remote
control, by matching
the polarity
(+ and -) on the batteries
with the + and - markings
on the battery
compartment.
When the remote control can no longer operate
the unit,
replace both batteries
at the same time.
1
2
R6P(SUM-3)/AA(15F)
/
/
3
• DO NOT use an old batlery together with a new one.
• DO NOT use different types of batleries together.
• DO NOT expose batleries to heat or flame.
• DO NOT leave the batteries in the batlery
compartment when you are not going to use the
remole control for an exlended period of time.
Olherwise, it will be damaged from battery leakage.
Connecting Antennas
FMantenna
FM antenna (supplied)
1 Attach
the FM antenna to the FM [75 f2]
coaxial terminal.
2 Extend
the FM antenna.
3 Fasten
it up in the position
which
gives you
the best
reception,
then fix it on the wail, etc.
_
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
Before connecting
it, disconnect
the supplied
FM antenna.
Outdoor FM antenna
(not supplied)
/
A 75 _ antenna with coaxial type connector (DIN 45325)
should be used.
6
Advertisement
Table of Contents
