Operating During Power Failure - Jenn-Air CCG2523 Guide Manual

Using Your Cooktop
Operating During Power Failure
Hold a lighted match to the desired surface burner near the
burrlcr porls.
Push down and slowly turn lhe control knob
counterclockwise to the Hi setting.
NOT\E: Do m)t leave the cooktop unattended when cook-
] ing during a power,fidlure. The atttomatic re-ignition
f_,ature will not operate during a powerJMlure.
Lo Flame Adjustment
This appliance has been shipped fron_ the factory with Lo
and Meal l]ame settings adjusted for use with natural gas and
average installations,
There is a wide variety of conditions caused by altitude and
gas mixtures controlled by utility companies which w ill vary
and aftlect the gas flame and performance, Adjustments
should be made at time of installation,
If conditions change, follow the procedures outlined below
to adjust the Lo setting,
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stein.
.
,
CAUTION: Never use a
metal blade to pry knob
off:
Insert a
slender, thin-blade
screwdriver into the recess
at centeF ()_*
valve stem
and engage blade with slot
in acUusting screw.
COUNTERCLOCKWIS[
TO INCREASE FLAME
,_ S_ZE
CLOCKWISE
TO
REDUCE J
LA. ,ZE
VALVE
Turn center stem adjusting screw slightly to set flame size.
Note: Turn clockwise to reduce or counter-clockwi_e Io
ire'tease jlame si=e.
5. Replace control knot) when a[justment is completed.
Proper adjustment will produce a stable, steady blue flame of
mininmm size. The final adjustment should be checked by
turning knob from Hi to Lo several times without
extinguishing the flame.