Fault Codes - Jenn-Air JER8785QAF Use & Care Manual

÷
÷
To set the C[ock: .............. ,
Clock
1. Press the Clock pad. , .............
° The time of day flashes in the dispby.
2. Press the appropriate number pads to set the time of day.
° Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
° The colon wiiI remain on.
When ebctricaI power is suppibd or after a power interrup-
tion, the last dock time before power was interrupted wiiI
flash.
To recall the time of day when another time function is
showing, press the Clock pad.
Clock time cannot be changed when the oven has been
programmed for Dday cook or dean or Cook & Hold.
To cancem the Clock display:
If you do not want the time of day to display:
Press and hold the CANCEL and Clock pads ....................... ,
Clock pad to briefly display the time of day. .........
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The display
will be blank and the oven light will not operate. To "wake up"
the control from Standby Mode, press any touchpad. A double
beep will sound.
To restore the Cmock display:
Press and hold the CANCEL and Clock pads for three sec-
onds. The time of day will reappear in the display.
The timer can be set from one minute (0:01} up to 99 hours
and 59 minutes (99:59}.
The timer can be used independently of any other oven
activity. It can also be set while another oven function is
operating.
The Timer does not control the oven. It only controls a
beeper.
To set the Timer:
Timer :
/
1. Press the Timer pad. "........
° 0:00 and TIMER flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
° The colon and TIMER wiii continue to flash.
3. Press Timer pad again or wait four seconds.
° The colon stops flashing and the time begins counting
down.
° The last minute of the timer countdown wiii be displayed
in seconds.
4. At the end of the set time, one long beep wiii sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancem the Timer:
1. Press and hold the Timer pad for three seconds.
OR
2. Press the Timer pad and press '0'
\
using the number pads. 0
Locking the Control
and Oven Door
The touchpad and oven door call be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day wiii remain in the display when the
touchpads and door are locked.
To lock: ............
Press and hold tile CANCEL and Cook & r_:[\_ CEL
Hold pads for three seconds. (Press [ ::::::::::::::::::::::::
CANCEL pad first.} Cook &
° OFF appears in the display. Hold
° LOCK flashes while the door is
locking.
To unlock:
Press and hold the CANCEL and Cook & Hold pads for three
seconds. (Press CANCEL pad first.} OFFdisappears from the
display.
Note: The touchpads and oven door cannot be locked if
the oven temperature is 400° F or above.
Fault Codes
BAKE or LOCK may flash rapidly ill the display to alert you if
there is all error or a problem. [f BAKE or LOCK flash ill the
display, press the CANCEL pad. [f BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes,
and then reconnect power. [f the flashing still continues,
disconnect power to the appliance and call an authorized
servicer.
10
÷
8113 P417-60B 11 _ 9/28/04, 11:40 AM